7What occurs to frames during the process of frame flooding?
8What is the destination MAC address of a broadcast frame?
9What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?
11Which component of an Ethernet frame is used to notify a host that traffic is coming?
14After the switch configurationthe ping test fails between PC A and PC B . Based on the output for switch 1which error must be corrected?
16Refer to the exhibit. Which VLAN ID is associated with the default VLAN in the given environment?
18Refer to the exhibit. How will switch SW2 handle traffic from VLAN 10 on SW1?
19Which type does a port become when it receives the best BPDU on a bridge?
20Which value can you modify to configure a specific interface as the preferred forwarding interface?
22Which result occurs when PortFast is enabled on an interface that is connected to another switch?
23What is the primary effect of the spanning-tree portfast command?
24How does STP prevent forwarding loops at OSI Layer 2?
25Refer to the exhibit. C-router is to be used as a “router-on-a-stick” to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.What is true about this configuration?
26On a corporate networkhosts on the same VLAN can communicate with each otherbut they are unable to communicate with hosts on different VLANs. What is needed to allow communication between the VLANs?
27Refer to the exhibit. The network administrator wants VLAN 67 traffic to be untagged between Switch 1 and Switch 2while all other VLANs are to remain tagged. Which command accomplishes this task?
